Just edit this element to add your own HTML.
SydMor Stables, LLC
SydMor Equestrian Center, LLC
SydMor Arena, LLC
SydMor Stables is now the “official “ supplier of MAG Flakes for our area for dust control for your indoor arena. We have 3 indoor arenas and have tested 2 of them over the last 45 days. What a difference this makes for you and your horses health. As we all know dusty and frozen arenas are something we deal with in Western Pennsylvania.
There are an infinite variety of blends of footing materials that are used in indoor equestrian riding arenas. The common problem in all footings is that they start out great but over time quickly develop nuisance dust because the footing is pulverized by the hoof action of constant riding and pounding.
Footing compositions are a very individual thing. Some may prefer a “Palomino” mix of sand and stone dust, while others want a blend of wood, sand, and stone dust, with crumb rubber or chip rubber and sand. There is no limit to the formulas of footings for each individual facility. The common denominator is that over time they all break down, and dust becomes a problem. Even rubber products will break down and eventually become airborne dust particles. Hunter Jumper arenas want footings that are firm but cushy while dressage arenas want a highly consistent footing with about 2-3 inches of loose footing on the surface. Each of these materials presents different potential dust problems.
Water is a viable solution (pun intended) for dust problems in many areas, but it does not come without costs. You must have the water or purchase it, then dispense it with a sprinkler system, and then that sprinkler system must be maintained, which means pumps, pipes, hoses, and potential plumbing problems.
Enter MAG, a proven humectant or hygroscopic agent that draws in moisture naturally. MAG is an ultra pure form of magnesium chloride that is harvested from the Dead Sea, a source of life giving minerals. MAG will draw in water and then hold it at an impressive rate. One pound of MAG can hold up to four times its weight in water under ideal conditions. MAG will draw in moisture continuously and indefinitely and suppress dust permanently in any type of footing in any indoor arena.
Applying MAG to an indoor ring is all art and a little science. Recognizing that footings are very individual, the objective in all footings is to maintain a consistent level of loose material to provide the desired amount of give.
Do Not Water!!!
The worst thing that you can do when using MAG is to water your ring. Once you commit to using MAG, it is very important that all watering for dust control is halted following the first application. The reason is simple: You are applying a dust control agent at the surface, and gravity and hoof action will help it to penetrate the footing, coat all the particles of footing and hold them down on the arena floor where you want them. By watering after you have applied MAG, you are rinsing the product off the top and into the subsurface.
How Much MAG do I need?
The amount needed varies depending upon the size of your ring, the footing composition, and depth, but generally speaking we find that the average indoor arena will need 2 to 4 pallets of our MAG to achieve complete dust stabilization and freeze-proofing in the average 75’ x 150’ indoor with all sand footing. Once the ring is completely stabilized you NEVER need to water again. In fact, watering the ring after it is stabilized with MAG is counterproductive and rinses the MAG down into the base away from the surface where dust emanates. Typically, a maintenance dose of 25% of the initial stabilization quantity is needed annually to cover new dust fines from the footing generated from normal use. Small or private low volume facilities may not need any touching up for years. It all depends on your traffic load and commitment to grooming the surface as well as picking up manure which is a significant source of dust in most arenas.
Is MAG Safe to Use?
MAG is very safe to use and handle. The Occupational Safety and Health Administration (OSHA) uses a document called a “Material Safety Data Sheet” (MSDS) to standardize information about all materials. On this form OSHA uses an industry standard for toxicity called an “LD50”, which is the amount of material that is required to kill at least 50% of the test subjects. While this is a morbid thought, it is the standard that the government has established and is recognized industry wide. The LD50 for strychnine, a rat poison, is 16 (milligrams per kilogram of body weight). The LD 50 for aspirin and calcium chloride is 1000 mg/kg. The LD50 for table is salt 3,000, and the LD50 for MAG is 8,100! That means that MAG is 2.5 times less toxic than table salt, is about half as toxic as baking soda and is very comparable to vitamin C, ascorbic acid.
How long will MAG last?
MAG will last forever, or until you wash it away with water or add new footing. If you have high organic materials in your footing, it will absorb the MAG and require more product and more maintenance.
How do I maintain my footing once it is fully stabilized?
This is the most important part of any successful program; Maintenance. You change the oil in the tractor, the car, and grease and maintain all the other tools of horse management so why wouldn’t you also maintain your riding surface? We recommend that you regularly groom your riding surface with either a tine harrow or other drag-type device which will pull the footing up and turn it over. Even an old piece of chain link fence dragged behind a machine will smooth out and level the riding surface. More often than not, the highest levels of dust are seen when grooming an untreated indoor ring. The best grooming devices are ones which have “teeth” that will dig into the footing and fluff it and turn it over while smoothing it out at the same time.
So, regular grooming is the #1 way to properly maintain your indoor ring once it is treated for dust. Next, a small maintenance dose of MAG to cover new dust fines which develop from on-going use, and, for use around the doorways or problem areas is recommended. The average 100 X 200 indoor ring will take three pallets of MAG to fully stabilize and then one pallet of MAG per year to maintain. Compare these costs to the costs of a sprinkler system and frozen footing in the winter.
Frozen Toes Made you close?
There is a side benefit to MAG stabilization that has not been mentioned: freeze proofing your ring. You will never again be forced to shut down in winter because the water saturated footing in your indoor froze up, and you could not ride in it because it is like a frozen moonscape. MAG will keep the same consistency in your footing throughout the year including those sub-zero days when you were not able to ride because the indoor was hard as a stone.
Is MAG the same as the liquid stuff being offered?
No! MAG is not a liquid; it’s dry flake form! Recently, others have begun to try to capitalize on the enormous success of our MAG. Some companies now offer a modified liquid product which appears to be a blend of unknown waste corn or agricultural chemicals and claimed to be mixed with an unknown source of magnesium. Do not be mislead by others claiming to offer the performance of our MAG in liquid form. It’s impossible to have the same performance of a dry product in liquid form, even if you were to liquefy MAG and then mix it with something else. Only MAG offers our absolute performance guarantee for dust control in your footing.
Nuts and Bolts – How to apply MAG
Think of applying MAG to your indoor as though you are fertilizing your lawn. You want to get even, thorough coverage. To do this we recommend the use of a broadcast spreader, or rotary spreader. We have had excellent results using a Brinley 150 lb. spreader that Home Depot sells for less than $200.00. It is mostly plastic with stainless steel knife gate and application adjustments.
Using a rotary spreader, fill the spreader to capacity and begin at the far end of the arena away from the “stockpile” of MAG. Open the spreader up to full capacity (wide open) and then begin by making a checkerboard pattern going first north and south in your arena and then east and west over the same area in a checkerboard pattern. When MAG is properly applied, it will look like it just snowed a light snow in the indoor. You will immediately see MAG start to pull in moisture and dissolve into the footing. This is what it’s supposed to do and what will control dust.
Realize that a treated ring needs some time to equilibrate or settle. While the first day after the first treatment you may think that you are all set, we find that a week or two later dust may begin to break through a little as the fines underneath the surface begin to work up and need to be treated. Typically a small maintenance dose of MAG is required from time to time to suppress new fines as they develop in normal ring use and around doorways and entries where rain may wash away some of the treatment, or where dirt and other sources of dust are dragged in to the arena.
Getting a proper analysis by one of our trained experts is vital to successful MAG use. Footings which contain high levels of organic materials will require more MAG to stabilize than arenas that are 100% mineral such as sand, blue stone, stone dust, etc. Organic materials which we see in arena footings are things like loam, sawdust, bark mulch, shavings, manure, hay dust (do you store hay in your indoor?), and many natural fibers along with some synthetic fibers. Some ground up “waste rubber” additives can contain materials that are capillary and porous adding to the amount of dust abatement material you’ll need. No matter what you are using for dust control, if you have organic materials in your footing the amount of any dust suppressant will be higher because these materials will suck up any dust suppressant that is added to the footing; water, mineral oil, MAG, or some of polymer additives that are out there. Armed with this knowledge, it is helpful to carefully evaluate your footing by looking at it closely for signs that it might contain some of these organic materials.
No two footings are alike!
Be aware that when we are asked to stabilize footings with high levels of organic material components, it is expected and likely that it will take much more MAG to stabilize. In fact, in some cases we’ve found that it can 3-5 times as much MAG to stabilize high levels of organic based footing materials than it will mineral based footing materials. That is true of any dust control material used whether its mineral oil, polymer, water, or our MAG. Organic materials like hay and wood are capillary and sponge like, so they will absorb exponentially more treatment (and if using water it will evaporate much more quickly too) and this is why it is vital that you consult with one of our footings experts to run an analysis on your footing to determine how much it will take. When you work with one of our experts, it also ensures our 100% satisfaction or money back guarantee.
Understanding the composition of your footing, and more importantly the source of the dust, is a critical component to managing the dust no matter what you are using for dust control. Think of MAG as a dry form of water and add it until the footing is dust free, and the weight, dampness, and consistency you want for your type of riding.
Prepare your ring to be treated by grooming and leveling.
Use a checkerboard pattern to apply product evenly.
DO NOT WATER – EVER! (It is ok to “spritz” the ring once.)
Thoroughly rinse down all equipment after each application.
Packaged in heat sealed 50 lb. poly bags – 48 bags per pallet.:
Within 24 hours, the MAG will dissolve and will wet the ring surface down. This will continue to improve and penetrate the footing as hoof traffic and use drives the product into the footing. Type your paragraph here.